Plastic Power Adhesive 2K
fast-hardening special adhesive (1:1)
For bonding plastic components and for filling deeper holes in plastic parts. Processing in layers is possible. Curing process can be accelerated with metered heat.
Processing:
- Clean the adhesive surfaces thoroughly, roughen them and remove the sanding dust with a silicone remover or the carVice controller.
- Spray the substrate thinly with a plastic adhesion promoter / primer and leave to dry.
- Insert the cartridge into the dispensing gun and attach a mixer nozzle to the cartridge.
- Apply adhesive according to requirements and, if necessary, smooth.
- The mixture remains workable for approx. 3-4 minutes at 20 ° C. After approximately 45 minutes, the adhesive reaches a strength sufficient for machining (drilling, grinding, milling). The final strength is reached after 24 hours.
- Heat accelerates and cold delay the curing.
- The adhesive does not adhere to damp surfaces.